MP5Navy
April 22nd, 2002, 08:08 PM
Here is the list of bulbs you may need for our Pro5s.
Low Beam Head lights: H7
High Beams: 9005
Fog Lights: H3
Front Turn: 1157
Front Bumper Lense: 168/194
Rear Turn: 7440
Brake Light: 7443
Reverse Light: 912
Install tips from a WEST SIDER:
Removal of rear taillights to get to the bulbs does not require the removal of the plastic moulds in the trunk. Unfasten three screws by uncovering the round cover pieces in the moulding. Note: On the right side taillight one of the nuts can be found by uncovering the hatch that covers the jack. Now, pull the taillight out - I really mean PULL cause there are plastic fasteners that hold the taillights in (I used a screw driver to help me get a grip at the top of the tailight). The rest is a simple matter of twisting out the bulb you want and replacing.
Front turns just need to be twisted counter-clock wise to remove.
Bumper lenses can be removed by unscrewing two screws on the splash guards under the front bumper by the fenders. Just peel back the plastic to reveal the underside of the bumper's side (plastic will not break so just peel to reveal). On the back side of the lense there is a spring that needs to be compressed (spring is held on by a screw which does not need to be unscrewed). Reach up and compress the spring and push the lense outwards. As it pushes out push the lense towards the back of the car with your spare hand. The front of the lense will disengage from its clip. Now just pull - I mean PULL the lense and it will come out with a "pop". Untwist the light and the lense is ready to be replaced.
This was a long message but I thought some of the rookies might want to know.
Low Beam Head lights: H7
High Beams: 9005
Fog Lights: H3
Front Turn: 1157
Front Bumper Lense: 168/194
Rear Turn: 7440
Brake Light: 7443
Reverse Light: 912
Install tips from a WEST SIDER:
Removal of rear taillights to get to the bulbs does not require the removal of the plastic moulds in the trunk. Unfasten three screws by uncovering the round cover pieces in the moulding. Note: On the right side taillight one of the nuts can be found by uncovering the hatch that covers the jack. Now, pull the taillight out - I really mean PULL cause there are plastic fasteners that hold the taillights in (I used a screw driver to help me get a grip at the top of the tailight). The rest is a simple matter of twisting out the bulb you want and replacing.
Front turns just need to be twisted counter-clock wise to remove.
Bumper lenses can be removed by unscrewing two screws on the splash guards under the front bumper by the fenders. Just peel back the plastic to reveal the underside of the bumper's side (plastic will not break so just peel to reveal). On the back side of the lense there is a spring that needs to be compressed (spring is held on by a screw which does not need to be unscrewed). Reach up and compress the spring and push the lense outwards. As it pushes out push the lense towards the back of the car with your spare hand. The front of the lense will disengage from its clip. Now just pull - I mean PULL the lense and it will come out with a "pop". Untwist the light and the lense is ready to be replaced.
This was a long message but I thought some of the rookies might want to know.