wasn't there a how to for engine mounts ?

[2.0P5]

like topic said, wasn't there a how to for installing AWR engine mounts ??
I found the rear one, but I need the front one.
or did I saw it on the US board ??

[Junior]

Us.

[2.0P5]

still can't find it:confused:

[Junior]

http://www.toprotege.com/forums/showthread.php?t=11893

[Spyder01]

I found the rear one, but I need the front one.


*cough cough... :D westsider :D

[sylvestre]

loosen two lower bolts on the existing mount, connecting to frame. loosen bolt going through rubber holding top of mount. do this first before jacking up car cause bolts are fricking tight. I think it's a 17mm (or so).

after doing this, jack up car and support engine. remove all nuts/bolts, take out mount, put in new one. put in new bolts.
for some reason I'm thinking there are different sizes and maybe some washers involved but hey, that's off the top of my head :)

[2.0P5]

ya ..those bolts are a bitch to get off ...
I end up taking it to my friends shop to get them loosen ..so in the end I had them install it for me, but it was free....:p