Wiring Harnesses

[tiwing]

I'm going to be wiring in gauges, a few LEDs, and separate dimmers for the gauges and LEDs, and some other electric accessories into my ride in the next few months. I also want to rewire my fog lights properly. Does anyone know where I can get 4, 6, 8, or 10 wire harness/plugs (both the male and female ends)? I've looked at a few CTs and all they have is for driving lights. I really don't want to use a whole mess of bullet or spade connectors...

thanks.

[CrazyCaker]

Just a shot in the dark here, but have you tried any electronic surplus stores? I seem to remember some of them carrying that type of thing.

[Scooter]

Try calling Best Buy to se if they might have them. They have the ones for H/U's (and probably only those), but it doesn't hurt to try.

Also, try asking at any Performance Auto shop. If they don't have them, I'm sure they could direct you to someone that would.

[bluezoom]

Are you looking for some sort of pre-fab harness, or do you want to make your own? If you're making your own, try an electronics place called Sayal. They've got a lot of different connectors there. You should be able to find what you're looking for.
They're on the north side of Matheson Blvd, just west of Dixie Rd.
Sayal Electronics (http://www.sayal.com/)

[tiwing]

Just looking for the standard plastic plug togethers that have 4 or 6 or whatever wires sticking out of each side, like the H/U ones but less wires. Thanks for the ideas. I'll post up when I eventually find some. I'm lazy though so it'll prob take a while.